Quote:
Originally Posted by jmb18
Mike,
I don't have the Flex 3401, I only have a rotary polisher and a GG 6 orbital.
So I have a few questions:
1. Do I have the above steps basically correct?
|
See comments in my first reply. The Captain's Boat Coating states to use the Marine 31 all purpose cleaner to wipe the gel-coat hull down after the last polishing step to remove any polishing oils.
While this will work I prefer to use a product in the BLACKFIRE line called,
BLACKFIRE Crystal Coat Paint Prep
It simply wipes easier and leaves a streak-free finish while an APC or All Purpose Cleaner doesn't wipe as easily or leave as nice a looking surface.
Quote:
Originally Posted by jmb18
2. I understand the benefit of the forced rotation of the 3401, but without out that would you recommend the polishing step using the Captain's One step with the rotary and a foam pad or the GG6 with a foam pad?
|
I'd go with the Griot's Garage 6" Dual Action Polisher after using the rotary buffer.
In my how-to book I recommend firmer, sharper cutting pads for polishing versus polishing pads as gel-coats don't seem to like soft foam pads? Never figured out why I just know what I see.
For your Griot's Garage polisher, what size backing plate do you have?
5" or 6"
Quote:
Originally Posted by jmb18
3. Finally, I am considering getting a GG Boss 15. How would the Boss compare to the 3401 for the polishing step?
|
The Griot's Garage BOSS G15 works GREAT for the polishing step on gel-coat boats.
Same tip as I mentioned above, that is use a foam cutting pad for the polishing step instead of a soft foam polishing pad and my experience is you create a nicer looking finish.
Let me know which tool your going to end up using and if it's the 6" DA polisher then what size backing plate and I'll recommend a foam pad.